Searching for Osha Support Trench Depth information? Find all needed info by using official links provided below.
https://www.osha.gov/Publications/trench_excavation_fs.html
OSHA requires safe access and egress to all excavations, including ladders, steps, ramps, or other safe means of exit for employees working in trench excavations 4 feet (1.22 meters) or deeper. These devices must be located within 25 feet (7.6 meters) of all workers.
https://www.osha.gov/OshDoc/data_Hurricane_Facts/trench_excavation_fs.pdf
OSHA standards require that employers provide workplaces free of recognized hazards. The employer must comply with the trenching and excavation requirements of 29 CFR 1926.651 and 1926.652 or comparable OSHA-approved state plan requirements. Trench Safety Measures Trenches 5 feet (1.5 meters) deep or greater
https://www.osha.gov/Publications/osha2226.pdf
and a trench? OSHA defines an excavation as any man-made cut, cavity, trench, or depression in the Earth’s surface formed by earth removal. A trench is defined as a narrow excavation (in relation to its length) made below the surface of the ground. In general, the depth of a trench is greater than its width, but the width of a trench
https://www.osha.gov/laws-regs/regulations/standardnumber/1926/1926.652
Excavation of material to a level no greater than 2 feet (.61 m) below the bottom of the members of a support system shall be permitted, but only if the system is designed to resist the forces calculated for the full depth of the trench, and there are no indications while the trench is open of a possible loss of soil from behind or below the ...
https://www.osha.gov/laws-regs/standardinterpretations/1976-09-14
This point would be 2.5 feet away from the edge of the trench. All material above the 5 feet line and over to the stable slope shall be removed, since the sides of trenches in hard or compact soil, 5 feet or less in depth, will normally stand without further support. Another option would be to bench at each additional 5 …
https://www.haspod.com/blog/construction/excavations-and-the-1-2-m-rule
The basis of the rule is that, if a trench is under 1.2m deep, then people can enter the trench without the sides of the excavation being supported or battered back. This rule is no longer something that should be considered. 1.2m is no longer the threshold for the need to support an excavation.
How to find Osha Support Trench Depth information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
