Searching for Nexus Pagp Support information? Find all needed info by using official links provided below.
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus5000/sw/configuration/guide/cli/CLIConfigurationGuide/EtherChannel.html
May 07, 2019 · Note Cisco NX-OS does not support Port Aggregation Protocol (PAgP) for port channels. A port channel bundles individual links into a channel group to create a single logical link that provides the aggregate bandwidth of up to eight physical links.
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx-os/interfaces/configuration/guide/if_nxos/if_portchannel.html
May 27, 2018 · The Cisco Nexus 7000 performs this optimization by default, and does not require or support this command. Cisco NX-OS does support the customization of the load-balancing criteria on port channels through the port-channel load-balance ethernet command, either for the entire device or on a per-module basis
https://www.cisco.com/c/en/us/support/docs/lan-switching/etherchannel/12023-4.html
Jul 09, 2007 · PAgP modes are off, auto, desirable, and on. Only the combinations auto-desirable, desirable-desirable, and on-on allow the formation of a channel. The device on the other side must have PAgP set to on if a device on one side of the channel does not support PAgP, such as a router. PAgP is currently supported on these switches: Catalyst 4500/4000
https://community.cisco.com/t5/storage-networking/port-channel-not-working-between-nexus-5548up-and-6513-catalyst/td-p/2426496
By contrast the Cisco Nexus only supports the standards based LACP. The default mode on the Catalyst switch is PAgP which you should be able to see under the Protocol column in the output of the show etherchannel summary command on the Catalyst switch.
http://www.firewall.cx/cisco-technical-knowledgebase/cisco-wireless/1223-how-to-configure-wlc-lag-and-port-channel-with-nexus-catalyst-switches.html
Cisco Wireless Controllers (WLC) support the configuration of Link Aggregation (IEEE 802.3ad - LAG) which bundles the controller ports into a single port channel.5/5(2)
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus1000/sw/4_0_4_s_v_1_3/interface/configuration/guide/n1000v_if/n1000v_if_5portchannel.pdf
Note The device does not support Port Aggregation Protocol (PAgP) for port channels. Each port can be in only one port channel. All the ports in a port channel must be compatible; they must use the same speed and duplex mode (see the “Compatibility Checks” section on page 5-2). When you
https://support.google.com/nexus/?hl=en
Official Nexus Help Center where you can find tips and tutorials on using Nexus and other answers to frequently asked questions.
https://netcraftsmen.com/what-features-does-the-nexus-9k-support/
Ever since I heard that the Nexus 9K has 50% less code, I've been wondering what features were removed from the code. So I did my best to figure it out, since I haven't seen a detailed features list from Cisco yet (early days and all that). I've also noticed that in general the Nexus team historically has put out long lists of supported features, leaving me thinking "yes, that's great -- but ...
How to find Nexus Pagp Support information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
