Searching for Does Catalyst 4500 Support Vss information? Find all needed info by using official links provided below.
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/20ew/configuration/guide/config/RPR.html
Dynamic state information (such as border gateway protocol [BGP] session information) is lost at switchover. • The Catalyst 4507R switch and the 4510R switches are the only Catalyst 4500 series switch that support supervisor engine redundancy.
https://blog.router-switch.com/2015/07/whats-new-on-cisco-catalyst-4500-vss/
Jul 22, 2015 · VSS (Virtual Switching Systems) combines a pair of Cisco Catalyst 4500 or 4500-X series switches into a single network element. It requires 2 chassis with 2 supervisors; the benefit is not only for the chassis redundancy, but also to double the system …
https://ciscoswitchestips.weebly.com/vss-configuration-for-cisco-4500-series-switches.html
Catalyst 4500/4500-X series switches' VSS does not support route processor redundancy (RPR) mode. Prerequisite: Before configuring VSS on Cisco 4500 please verify hardware and software requirement.
https://blog.router-switch.com/2014/08/vss-on-cisco-45004500x-switches/
Aug 29, 2014 · Support for Layer 3 MEC—VSS with Layer 3 Multichassis EtherChannel (MEC) at the aggregation layer Support for VSLP Fast Hello—With VSLP Fast Hello, the Catalyst 4500-X configured for VSS can now connect Access Switches that do not support the ePAgP protocol.
https://community.cisco.com/t5/switching/vss-support-on-cat-4500x/td-p/1942009
the Supervisor Engine 7-E and 7-LE will support vss with a IP base license. The release date is not availible yet. There will by a new 4500x serie switches replacement of the 4948 that will also support vss with 4 modulere slots wich can hold up to 16 10Gig sfp(+) or ethernet interfaces.
https://trlj.blogspot.com/2016/06/virtual-switching-system-cisco-4500.html
Jun 29, 2016 · Catalyst 4500/4500-X series switches’ VSS does not support route processor redundancy (RPR) mode like 6500 does. The failed switch performs recovery action by reloading the supervisor engine. If the VSS standby switch or supervisor engine fails, no switchover is required.Author: Learning Journal
https://refer-points.blogspot.com/2014/05/virtual-switching-system-vss.html
May 26, 2014 · Catalyst 4500/4500-X series switches' VSS does not support route processor redundancy (RPR) mode. Prerequisite: Before configuring VSS on Cisco 4500 please verify hardware and software requirement.
https://community.fs.com/blog/optics-solutions-for-cisco-catalyst-4500-x-series-switch.html
Any two Cisco Catalyst 4500-X series switches can be pooled together into a VSS (shown in the figure below). Once a VSS is created, it acts as a single virtual Cisco Catalyst switch which simplifies configuration while providing a higher level of availability.
How to find Does Catalyst 4500 Support Vss information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
