Searching for Cisco Switches That Support Routing information? Find all needed info by using official links provided below.
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9600/software/release/17-1/configuration_guide/ip_mcast_rtng/b_171_ip_mcast_rtng_9600_cg/configuring_multicast_vpn_extranet_support.html
Dec 23, 2019 · IP Multicast Routing Configuration Guide, Cisco IOS XE Amsterdam 17.1.x (Catalyst 9600 Switches) Chapter Title. Configuring Multicast VPN Extranet Support. PDF - Complete Book (6.49 MB) PDF - This Chapter (1.57 MB) View with Adobe Reader on a variety of devices
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960x/software/15-0_2_EX/routing/configuration_guide/b_rt_152ex_2960-x_cg/b_rt_152ex_2960-x_cg_chapter_010.html
Enable IP routing on the switch. Assign IP addresses to the Layer 3 interfaces. Configure static routes. Enabling IP Unicast Routing. By default, the switch is in Layer 2 switching mode and IP routing is disabled. To use the Layer 3 capabilities of the switch, you must enable IP routing.
https://community.cisco.com/t5/switching/is-it-supporting-static-routing-in-lan-base/td-p/2818298
Hey you will need an ipbase. Hey you will need an ipbase license to get the static routing and ip services for features like eigrp or pbr ,lanbase is a purely layer 2 image for switching only.You buy the license seperatly like most Cisco platforms. The IP Base feature set includes advanced quality of service (QoS), rate limiting,...
https://www.cisco.com/c/en/us/support/docs/switches/catalyst-3750-series-switches/45002-intervlan3750-45002.html
Nov 17, 2007 · This document provides a sample configuration for inter-VLAN routing using two Catalyst 3750s series switches stacked together running EMI software in a typical network scenario. The document uses a Catalyst 2950 series switch and a Catalyst 2948G switch as Layer 2 (L2) closet switches connecting to the stack of Catalyst 3750s.
https://www.cisco.com/c/en/us/support/docs/lan-switching/inter-vlan-routing/41860-howto-L3-intervlanrouting.pdf
Complete these steps in order to configure a switch to perform interVLAN routing. Enable routing on the switch with the ip routing command. Note: If the switch does not accept the ip routing command, upgrade to either SMI image Cisco IOS Software Release12.1(11)EA1 or later, …
How to find Cisco Switches That Support Routing information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
