Searching for Wanz Support Bar Sizes information? Find all needed info by using official links provided below.
https://www.altuswindows.co.nz/media/1962/altus_wanz-guide-e2-as1-amd-7-v14-nov-2017.pdf
Window Association of New Zealand Page 12. Step C1 – Sill Support Bar. Clause 9.1.10.5 b) v) describes the requirements of the Sill Support bar in terms of compliance with E2/AS1. There are some important points to note; a. Support is required on all window and door units with a trim opening over 600mm wide, b. The sill support bar must ...
http://www.bradnams.co.nz/index.pl?page=flashings&m=76
A standard 15° slope applies to our flashing range. The range includes 11 sizes: 84mm, 71mm, 63mm, 58mm, 53mm, 48mm, 41mm, 38mm, 31mm, 25mm, and 14mm. These flashings meet the design requirements that support the NZ Building Code Clause E2/AS1 Amendment 5 and those of the WANZ WIS alternative solution.
http://www.nulook.co.nz/index.pl?page=wanz_wiz&m=135
WANZ WIS Installation Guide About WANZ WIS... For residential construction we recommend you follow the WANZ WIS installation guidelines, showing head flashing placement and location, and the use of WANZ sill support bars when using cavity construction.
https://www.branz.co.nz/cms_show_download.php?id=f8ded3a75da02806a106e8bc05cd049771992189
separately supported. Figure 1 illustrates the use of such a support, which in this instance is a WANZ bar. This eccentric load will induce a large tension force in the screw fixing the support bar to the sill trimmer. This report examines whether a proposed new WANZ support bar and fixings are adequate for most window situations.
Windows Association of New Zealand. Asian Architects looking to create modern and foreclosed houses and buildings using lasting, ecofriendly and economical doors and windows really are relying upon aluminum technology.
http://www.mckechnie.co.nz/products/stocked-products.html
Stocked Sections. McKechnie offer an extensive range of extrusions New Zealand wide. From angles to channels and in a variety of sizes and finishes including anodised and powder coated. Stocked Sections Catalogue - as at Sept 2019
http://www.nulook.co.nz/index.pl?page=flashings
A standard 15° slope applies to our flashing range. The range includes 14 sizes: 95mm, 84mm,71mm, 68mm, 63mm, 58mm, 53mm, 48mm, 45mm, 41mm, 38mm, 31mm, 25mm and 14mm. These flashings meet the design requirements that support the NZ Building Code Clause E2/AS1 Amendment 6 requirements and those of the WANZ WIS alternative solution.
How to find Wanz Support Bar Sizes information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
