Searching for Switch Support Multicast information? Find all needed info by using official links provided below.
https://www.cisco.com/c/en/us/support/docs/ip/ip-multicast/29480-167.html
Feb 26, 2019 · GMRP and RGMP Catalyst Switches Support Matrix Refer to the IP Multicast support page for additional information on implementing the multicast feature and for sample configurations and troubleshooting tips.
https://documentation.meraki.com/zGeneral_Administration/Other_Topics/Multicast_support
Navigate to Switch > Configure > Routing and DHCP. Select or Add an interface. Enter Name, Interface IP, and VLAN. Under multicast support, selection Enable IGMP snooping querier. Click Save.
https://community.cisco.com/t5/switching/multicast-switch-requirement/td-p/1536603
IGMP snooping catalyst support . If you don't have a switch that supports it and you don't have a L3 interface you can enable PIM on then unless you want all mutlicast to be treated as broadcast you willl have to statically assign the multicast mac-address to the relevant switch ports but obviously this means you cannot have dynamic membership ...
https://support.microsoft.com/en-us/help/4494444/configuring-network-infrastructure-to-support-the-nlb-operation-mode
Apr 05, 2019 · To support this configuration, you must configure the network infrastructure to use static ARP entries and MAC address table entries. Network switches cannot learn the NLB multicast MAC address in the course of their usual operations. If you skip the manual configuration step, the network switches may flood NLB traffic to all ports or drop packets.
https://www.cisco.com/en/US/tech/tk828/technologies_white_paper09186a0080092942.shtml
The most appropriate switches have a switch architecture that allows multicast traffic to be forwarded to a large number of attached group members without unduly loading the switch fabric. This allows the switch to provide support for the growing number of new multicast …
https://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/68131-cat-multicast-prob.html
Nov 16, 2006 · The multicast source is connected to Switch 1, which is a Catalyst 6500 Switch with Supervisor Engine 720 that runs Cisco IOS Software. Receiver 1 is connected to Switch 1, and Receiver 2 is connected to Switch 2. Switch 2 is a Catalyst 3750. There is a Layer 2 link, either access or trunk, between Switch 1 and Switch 2.
https://stackoverflow.com/questions/9379100/what-is-the-state-of-multicast-support-in-consumer-grade-routers
Are you talking switches or routers? In a consumer setting I suspect switches. My experience is that they all support multicast, though not at wire speed. Also the cheap ones tend to broadcast any multicast traffic to all ports (no IGMP snooping).
How to find Switch Support Multicast information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
