Searching for Snmptrap Ipv6 Support information? Find all needed info by using official links provided below.
https://techhub.hpe.com/eginfolib/networking/docs/switches/WB/15-18/5998-8170_wb_2920_ipv6_config_guide/content/v33585030.html
IPv6 is not supported in the configuration of an interface IPv6 address as the default source IP address used in the IP headers of SNMP notifications (traps and informs) or responses sent to SNMP requests. Only IPv4 addresses are supported in the following configuration commands:
https://www.ibm.com/support/knowledgecenter/en/ssw_aix_72/s_commands/snmptrap.html
snmptrap -h nehcyg –o 1.3.6.1.4.1.2.6.191.1.6.1.0 -m hello world To send a trap with the community1 community name, and the message hello world to the SNMP agent that is running on an IPv6 address, enter the following command:
https://support.nagios.com/kb/article/nagios-xi-receiving-ipv6-snmp-traps-499.html
Dec 18, 2018 · Subscribe to knowledge base Get notified when new articles are added to the knowledge base.1/5(2)
https://thwack.solarwinds.com/ideas/2400
Jun 24, 2013 · The SNMP trap receiver assumes that any SNMP TrapVarbind of type inetaddress is an IPv4 inet address; this presents a problem with devices sending IPv6 addresses in the trapvarbinds. An example is shown below:
https://stackoverflow.com/questions/4627698/snmp-trap-to-ipv6-address
Is anybody aware of (windows) utility which can send SNMP traps to IPv6 addresses? I've tried trapgen but it seems it's not able to work with IPv6 addresses. Also there is net-snmp windows port but it's a real pain to use it for sending traps. For me it didn't work at all. It always failed with "Cannot find module (TRAP-TEST-MIB):". Thanks.
How to find Snmptrap Ipv6 Support information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
