Searching for Procurve Sflow Support information? Find all needed info by using official links provided below.
https://techhub.hpe.com/eginfolib/networking/docs/switches/K-KA-KB/15-18/5998-8160_ssw_mcg/content/ch06s09.html
The version information shows the sFlow version, MIB support, and software versions; the agent address is typically the IP address of the first VLAN configured on the switch. Example of viewing sflow agent information. Syntax. show sflow receiver instance destination.
https://sflow.org/products/network.php
Network Equipment. The following devices are capable of exporting sFlow: 6WIND. 6WINDGate; 6WIND Turbo Router
https://blogs.manageengine.com/network/netflowanalyzer/2009/11/05/get-smart-use-netflow-analyzer-for-sflow-from-hp-procurve.html
Nov 05, 2009 · HP Procurve and sFlow: Just like Cisco has NetFlow and other vendors have thier flow formarts, some vendors use a technolgy called sFlow. HP Procurve devices are capable of exporting sFlow datagrams which can be used for bandwidth monitoring and traffic analysis. NetFlow Analyzer is capable of analyzing the sFlow datagram exported from the HP ...
https://inmon.com/products/sFlowTrend/help/html/appendix.switch-sflow.cli.html
All ProCurve switches that support sFlow (except the 9300 and 9400 series) can be configured using SNMP. In addition, the ProCurve 3500 and 5400 series switches can be configured to send sFlow using the CLI. (config)# sflow 1 destination 10.1.2.5 6343 (config)# sflow 1 sampling ethernet A1-A24 128 (config)# sflow 1 polling ethernet A1-A24 30 ...
https://inmon.com/pdf/AN-S7_InMon-traffic-sentinel-monitor-final-081808b.pdf
Traffic monitoring on ProCurve switches with sFlow and InMon Traffic Sentinel HP ProCurve Networking 3 1. Introduction This application note presents the monitoring and reporting capabilities of InMon Traffic Sentinel on ProCurve network equipment using the sFlow protocol. The application note focuses on InMon Traffic Sentinel configuration.
https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c02597339
Once sFlow is successfully configured, the switch's sFlow agent autonomously sends samples, via UDP, to the appropriate collector(s). It is possible to manually configure the SNMP MIBs. Following is a step-by-step example using an HP ProCurve 2800 Series switch.
How to find Procurve Sflow Support information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
