Searching for Interface Ppp0 Does Not Support Broadcast information? Find all needed info by using official links provided below.
https://unix.stackexchange.com/questions/315793/enabling-an-internet-route-through-ppp0
In both cases, calling curl --interface ppp0 ifconfig.co as root works and returns the IP address of the VPN connection, but I cannot execute the command as any other non-root user. The command curl --interface eth1 ifconfig.co works fine as root or a normal user.
https://unix.stackexchange.com/questions/68617/explanation-of-the-outputs-command-ifconfig-ppp0
explanation of the output's command “ifconfig ppp0” ... Note that I'm using an internet-usb-board and so I'm sure that ppp0 interface is associated to it. In particular I have these questions: What is the field P-t-P: ... does it mean that my subnet doesn't support multicast of level 2? bash ubuntu ip. share …
https://stackoverflow.com/questions/41249258/the-ppp0-interface-uses-the-eth0-interface
Thank you for your answer but it still doesn't work. As a matter of fact it is the ping via the ppp interface that uses the enp1s0 interface whereas the curl command succeeds in using both interfaces and this was already the case with my old configuration. – john Dec 21 '16 at 12:10
https://bugzilla.redhat.com/show_bug.cgi?id=626514
I did not say that dhclient does not work (in general), or that it does not support PD. Issues with dhclient are mainly with how does it work over ppp0 (ppp tunnel). In short, ppp0 is special interface, and it seems that dhclient is _unable_ to generate proper duid.
https://forums.gentoo.org/viewtopic-p-5092858.html
May 20, 2008 · ppp0: Device not found: View unanswered posts View posts from last 24 hours View posts from last 7 days Goto page 1, 2 Next
https://community.sophos.com/products/unified-threat-management/f/hardware-installation-up2date-licensing/83344/solved-wan-up-link-error/312063
Nov 11, 2016 · I do have a Realtek NIC on the WAN interface. And an additional Intel 82574L for the LAN. Changing to an Intel NIC is not a viable solution ATM; this machine has only one expansion I think... I may be able to swap them, though. I did follow the rule regarding fixed speed on the interface, though, and also changed the modem.
http://manpages.ubuntu.com/manpages/xenial/en/man5/shorewall-interfaces.5.html
If your iptables and/or kernel lack Address Type Match support then you may list the broadcast address(es) for the network(s) to which the interface belongs. For P-T-P interfaces…
https://serverfault.com/questions/128592/routing-specific-ip-to-ppp0-tunnel
You can verify with tcpdump - if you see traffic leaving the ppp0 interface but no return then it's likely the ppp peer. If you see no traffic then check the iptables settings. tcpdump -n ip host 208.85.40.20
http://www.shorewall.net/manpages/shorewall-interfaces.html
If your iptables and/or kernel lack Address Type Match support then you may list the broadcast address(es) for the network(s) to which the interface belongs. For P-T-P interfaces…
https://wiki.gentoo.org/wiki/Handbook:AMD64/Networking/Modular
VLAN (802.1q support) For VLAN support, make sure that sys-apps/iproute2 is installed and ensure that iproute2 is used as configuration module rather than ifconfig. Virtual LAN is a group of network devices that behave as if they were connected to a single network segment - even though they may not …
How to find Interface Ppp0 Does Not Support Broadcast information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
