Searching for Dfi Support Forums information? Find all needed info by using official links provided below.
https://www.dfi.com/Contact/Support
DFI’s single board computer with compact size and high flexibility features is ideal for your embedded development board and customized motherboard needs. ... Technical Support. Request assistance for technical issues and questions. Technical Support. Request assistance for technical issues and questions * Required Fields.
This is an example page. It’s different from a blog post because it will stay in one place and will show up in your site navigation (in most themes).
DFI’s single board computer with compact size and high flexibility features is ideal for your embedded development board and customized motherboard needs
http://www.ddr-phy.org/forum
Dec 11, 2019 · Latest Activity - Forum Discussions DFI is an industry spec that simplifies and defines a standard interface between the DDR memory controller logic and the…
http://ddr-phy.ning.com/forum?sort=mostRecentDiscussions
Dec 09, 2019 · Query in DFI Spec Frequency Ratio operation. Hi all, I have a doubt in DFI Spec Page number 118. In the PHY side waveform for the read operation, dfi_rddata_en gets asserted at phase… Started by Atanu Biswas. 3: Dec 5, 2019 Reply by John MacLaren: dfi_init_complete signal assertion DFI4 and DDR4. Hi, I'm new to DDR protocols.
http://www.ddr-phy.org/forum?page=20
May 22, 2013 · DFI 2.1 vs 3.0. Hello, if I have a Controller that support only DDR3 and DFI 2.1.1 and a PHY which support dfi 3.0 could I connect toghether ? There is som… Started by Gianluigi Senise. 2: May 22, 2013 Reply by Gianluigi Senise: Query regarding Tcmd_lat. Hi, I have a query regarding Tcmd_lat in DFI 3.0.
https://e2e.ti.com/support/power-management/f/196/t/102363
The DFI read/write description in SLUA379 app note applies to z65 (z65 is part of bq20zxx family) as well. The 0x800 size of DFI file created by bqEASY is to account for some of the latest devices. For devices that has less than 0x800 data size, bqEASY fill up the remaining DFI file with "0".
https://social.technet.microsoft.com/Forums/en-US/05fcaa94-cb60-454f-aea5-d24e23b33388/dfi-lanparty-jr-gf9400-t2rs
Dec 16, 2011 · You need to go to the DFI Support forums and discuss your problem there. Please remember to click “Mark as Answer” on the post that helps you, and to click “Unmark as Answer” if a marked post does not actually answer your question. This can be beneficial to other community members reading the thread.
https://e2e.ti.com/support/power-management/f/196/t/75365?Writing-DFI-File-at-production-
The .SENC contains the firmware that the gauge runs, while the DFI file contains only configuration parameters. Note, however, that a DFI file will only work with the firmware that it for which it was created. Once you have the latest SENC and DFI file, you use flashstream to generate a BQFS and DFFS file.
How to find Dfi Support Forums information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
