Searching for Cisco Pim Support information? Find all needed info by using official links provided below.
https://www.cisco.com/c/en/us/support/docs/ip/ip-multicast/9356-48.html
Aug 30, 2005 · Cisco recommends that you use Protocol Independent Multicast (PIM) sparse mode, particularly Auto-RP, where possible and especially for new deployments. However, if dense mode is desired, configure the global command ip multicast-routing and the interface command ip pim sparse-dense-mode on each interface that needs to process multicast traffic ...
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipmulti/command/imc-cr-book/imc_i3.html
Nov 21, 2018 · To log the Protocol Independent Multicast (PIM) ... This command is supported in the Cisco IOS Release 12.2SX train. Support in a specific 12.2SX release of this train depends on your feature set, platform, and platform hardware. ...
https://community.cisco.com/t5/networking-documents/pim/ta-p/3113154
Description: Protocol Independent Multicast (PIM) Complete Definition: Protocol-Independent Multicast (PIM) is a family of multicast routing protocols that can provide one-to-many and many-to-many distribution of data over the Internet. The "protocol-independent" part refers to the fact that PIM...
https://documentation.meraki.com/zGeneral_Administration/Other_Topics/Multicast_support
IGMP Support on the Cisco Meraki Switch. MS Switches can forward IGMP traffic, but will run IGMP snooping by default. This prevents the switch from sending multicast traffic to hosts who are not yet joined with the proper multicast group.
https://networklessons.com/multicast/multicast-pim-sparse-mode
In this lesson we'll take a look at PIM sparse mode which works about opposite of how PIM dense mode works. With PIM dense mode, we flood multicast traffic everywhere and then we prune it.
https://networklessons.com/multicast/multicast-bidirectional-pim
Another difference between PIM sparse mode and PIM bidirectional mode is that with sparse mode traffic only flows down the shared tree. Using PIM bidir mode traffic will flow up and down the shared tree! Also PIM bidirectional does not use the PIM register / register-stop mechanism to register sources to the RP. Each source is able to start ...
https://help.fortinet.com/fos50hlp/52data/Content/FortiOS/fortigate-firewall-52/Multicast%20Forwarding/PIM%20Support.htm
Client applications send multicast data by registering IP traffic with a PIM-enabled router. An end-user could type in a class D multicast group address, an alias for the multicast group address, or a call-conference number to initiate the session.
https://content.cisco.com/chapter.sjs?uri=%2Fsearchable%2Fchapter%2Fcontent%2Fen%2Fus%2Ftd%2Fdocs%2Fios-xml%2Fios%2Fipmulti_serv%2Fconfiguration%2Fxe-16-9%2Fimc-serv-xe-16-9-book%2Fimc-service-reflect.html.xml&platform=Cisco%204000%20Series%20Integrated%20Services%20Routers&release=IOS%20XE%20Fuji%2016.9.x
Multicast service reflection is implemented using an interface CLI statement. Each configured multicast service reflection CLI statement establishes a packet match and rewrite operation acting on packets sent by Cisco IOS unicast or multicast packet routing onto the Vif1 interface.
How to find Cisco Pim Support information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.