Cisco Asa Port Channel Support

Searching for Cisco Asa Port Channel Support information? Find all needed info by using official links provided below.


Cisco ASA 5500 Series Configuration Guide using the CLI, 8 ...

    https://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/interface_start.html
    Nov 14, 2018 · The device to which you connect the ASA EtherChannel must also support 802.3ad EtherChannels; for example, you can connect to the Catalyst 6500 switch. ... Jumbo packet support for the ASA 5580. 8.1(1) The Cisco ASA 5580 supports jumbo frames. A jumbo frame is an Ethernet packet larger than the standard maximum of 1518 bytes (including Layer 2 ...

Basic Interface Configuration (ASA 5512-X and Higher)

    https://www.cisco.com/c/en/us/td/docs/security/asa/asa92/asdm72/general/asa-general-asdm/interface-basic.pdf
    The device to which you connect the ASA EtherChannel must also support 802.3ad EtherChannels; for example, you can connect to the Cisco Catalyst 6500 switch or the Cisco Nexus 7000. When the switch is part of a Virtual Switching System (VSS) or Virtual Port Channel (vPC), then you

Cisco ASA 5525-X Adaptive Security Appliance - Cisco

    https://www.cisco.com/c/en/us/support/security/asa-5525-x-adaptive-security-appliance/model.html
    Feb 28, 2012 · ASA 9.5 (ASDM 7.5 is End of Support) CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.5 ; CLI Book 2: Cisco ASA Series Firewall CLI Configuration Guide, 9.5 ... Cisco ASA 5508-X and 5516-X Adaptive Security Appliance. Cisco ASA 5508-X and ASA 5516-X Hardware Installation Guide;

Etherchannel (Port Channel) on Cisco ASA Amir Montazeri

    http://www.amirmontazeri.com/?p=18
    Mar 05, 2013 · The other port-channel members on 4848 catalyst only have traffic in output direction. I am thinking because this is ASA L3 Port-Channel to Catalyst Switch L2 Port-Channel As per cisco-tac L3 Port-Channel to L2 Port-Channel wont load-balance properly You either do L2 – L2 Port-Channel or L3-L3 Port-Channel. Please advise

CLI Book 1: Cisco ASA Series General Operations CLI ...

    https://www.cisco.com/c/en/us/td/docs/security/asa/asa96/configuration/general/asa-96-general-config/interface-echannel.html
    Oct 16, 2019 · The device to which you connect the ASA EtherChannel must also support 802.3ad EtherChannels; for example, you can connect to the Catalyst 6500 switch or the Cisco Nexus 7000. When the switch is part of a Virtual Switching System (VSS) or Virtual Port Channel (vPC), then you can connect ASA interfaces within the same EtherChannel to separate switches in the VSS/vPC.

Cisco ASA 5500 Series Configuration Guide using the CLI, 8 ...

    https://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/interface_complete_routed.html
    Nov 14, 2018 · The ASA supports the configuration of both IPv6 and IPv4 on an interface. You do not need to enter any special commands to do so; simply enter the IPv4 configuration commands and IPv6 configuration commands as you normally would. Make sure …

Cisco ASA 5545-X Adaptive Security Appliance - Cisco

    https://www.cisco.com/c/en/us/support/security/asa-5545-x-adaptive-security-appliance/model.html
    Feb 28, 2012 · ASA 9.5 (ASDM 7.5 is End of Support) CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.5 ; CLI Book 2: Cisco ASA Series Firewall CLI Configuration Guide, 9.5 ... Cisco ASA 5508-X and 5516-X Adaptive Security Appliance. Cisco ASA 5508-X and ASA 5516-X Hardware Installation Guide;

Solved: Etherchannel on ASA - Cisco Community

    https://community.cisco.com/t5/firewalls/etherchannel-on-asa/td-p/1340158
    This is supported as of 8.4.1. EtherChannel support (ASA 5510 and higher) You can configure up to 48 802.3ad EtherChannels of eight active interfaces each. Note You cannot use interfaces on the 4GE SSM, including the integrated 4GE SSM in slot 1 on the ASA 5550, as part of an EtherChannel.

Cisco ASA Series CLI Configuration Guide, 9.0 ...

    https://www.cisco.com/c/en/us/td/docs/security/asa/asa90/configuration/guide/asa_90_cli_config/ha_cluster.html
    Sep 25, 2018 · Cisco ASA Series CLI Configuration Guide, 9.0. Chapter Title. ... See Table 1-1 for clustering support or lack of support for this kind of traffic. ... Do not change the load-balancing algorithm from the default on the ASA (in the port-channel load-balance command).



How to find Cisco Asa Port Channel Support information?

Follow the instuctions below:

  • Choose an official link provided above.
  • Click on it.
  • Find company email address & contact them via email
  • Find company phone & make a call.
  • Find company address & visit their office.

Related Companies Support