Searching for Cisco 3560 Lacp Support information? Find all needed info by using official links provided below.
https://community.cisco.com/t5/switching/trunking-over-lacp-on-3560-switch/td-p/1719908
I'm trying to run a trunk over a four port Lacp group to a netgear switch form a 3560 but am getting stuck. Everything works fine if I setup a trunk using a single standalone port, and everything works when I use a Lacp group in 'switchport access' mode, but as soon as I enable 'switchport trunk' the status of each gi goes to 'suspended' and no traffic will flow.
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3560/software/release/12-2_55_se/configuration/guide/3560_scg/swethchl.html
Apr 15, 2016 · Catalyst 3560 Switch Software Configuration Guide, Release 12.2(55)SE. ... Link Aggregation Control Protocol (LACP), or On. Configure both ends of the EtherChannel in the same mode: ... Contact Cisco. Open a Support Case (Requires a Cisco Service Contract) Related Cisco Community Discussions.
https://www.cisco.com/c/en/us/support/docs/lan-switching/etherchannel/12025-49.html
Jul 11, 2007 · Catalyst 3560 Series Switches. Refer to the support page for the Catalyst 3560 Series Switch for more information on these switches. Catalyst 3560 series switches support both Layer 2 and Layer 3 EtherChannel, with up to eight compatibly configured Ethernet interfaces. All interfaces in each EtherChannel must be the same speed.
https://community.cisco.com/t5/switching/lacp-config-on-3560g-switch/td-p/1341568
need help on configuring LACP on switch. Currently the config is as follows switchport access vlanx switch mode access channel-group 5 mode active I want to make sure if this config is correct and if there is anything missing. Please advice.
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750x_3560x/software/release/12-2_53_se/configuration/guide/3750xscg/swethchl.html
Sep 11, 2018 · Catalyst 3750-X and 3560-X Switch Software Configuration Guide, Release 12.2(53)SE2. Book Contents ... Link Aggregation Control Protocol (LACP), or On. Configure both ends of the EtherChannel in the same mode: ... Contact Cisco. Open a Support Case (Requires a Cisco Service Contract) Related Cisco Community Discussions.
https://www.cisco.com/c/en/us/support/switches/catalyst-3560-series-switches/tsd-products-support-series-home.html
Find software and support documentation to design, install and upgrade, configure, and troubleshoot Cisco Catalyst 3560 Series Switches.
How to find Cisco 3560 Lacp Support information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
