Searching for Can Tcp Support Multicast information? Find all needed info by using official links provided below.
http://www.tldp.org/HOWTO/Multicast-HOWTO-1.html
Multicast is much like radio or TV in the sense that only those who have tuned their receivers (by selecting a particular frequency they are interested on) receive the information. That is: you hear the channel you are interested in, but not the others. 1.2 The problem with Unicast. Unicast is anything that is not broadcast nor multicast.
https://www.tldp.org/HOWTO/Multicast-HOWTO-2.html
Hosts can be in three different levels of conformance with the Multicast specification, according to the requirements they meet. Level 0 is the "no support for IP Multicasting" level. Lots of hosts and routers in the Internet are in this state, as multicast support is not mandatory in IPv4 (it is, however, in IPv6).
https://blog.pythian.com/network-multicast-support-azure/
The output clearly tells us that we don’t have multicast support for either for 230.0.1.0 or 224.0.0.251 multicast addresses. What does the Virtual Network FAQ for Azure tell us about it? Here is the answer: Do VNets support multicast or broadcast? No. We do not support multicast or broadcast. What protocols can I use within VNets?
https://www.quora.com/Why-cant-TCP-be-used-for-multicast-or-broadcast-while-UDP-can
TCP is true end-to-end. A connection is being established between communicating end systems, and a meticulous book-keeping takes place with respect to bytes sent, received and successfully acknowledged by the receiver. Also mechanisms like congest...
https://community.cisco.com/t5/routing/tcp-udp-and-multicast/td-p/451895
You can't use TCP over Mcast since TCP is session based. As you stated UDP is the protocol of choice for Mcast applications. Other non session based protocol such as IGMP, OSPF, EIGRP, RIP also use Mcast for message delivery.
https://en.wikipedia.org/wiki/Multicast
Multicast can be one-to-many or many-to-many distribution. Multicast should not be confused with physical layer point-to-multipoint communication. Group communication may either be application layer multicast or network assisted multicast, where the latter makes it possible for the source to efficiently send to the group in a single transmission.
http://www.tcpipguide.com/free/t_IPMulticasting.htm
IP Multicasting (Page 1 of 2) The great bulk of TCP/IP communications uses the Internet Protocol to send messages from one source device to one recipient device; this is called unicast communications. This is the type of messaging we normally use TCP/IP for; when you use the Internet you are using unicast for pretty much everything.
How to find Can Tcp Support Multicast information?
Follow the instuctions below:
- Choose an official link provided above.
- Click on it.
- Find company email address & contact them via email
- Find company phone & make a call.
- Find company address & visit their office.
